Tip Dresser R1A

• Step feeding

• Air motor, 180 rpm

• Air pressure, 6-7 bar

• Electrode force, 3-4 kN

Tip Dresser R2B

• Dual cutter units

• Continous feeding

• Air motor, 200 rpm

• Air pressure, 6-7 bar

• Electrode force, 3-4 kN

• Rotation sensing

• Debris cleaning

Tip Dresser R1E

• Electric motor, 100 rpm

• Electrode force,  0,75-1,5 kN

• Supply voltage, 24VDC

• Power consumption, 200 W

Control and Powerbox PB R1E

Ready-to-use control and powerbox for the electric tip dresser R1E.

• Supply voltage, 380 VAC

• Control voltage, 24VDC 

Cutter units

The cutter unit consists of a contact diameter dependent blade adaptor, the cutter blade and a fitting screw. It is available in many different variants to match different electrode designs. The reaming tool in the cutter is a cost efficient standard SANDVIKEN off-the-shelf tool.

• Contact diameter, 4-8 mm

• Electrode diameter, 13-20 mm

• Tip angle, max 120°

• Thickness, 15 mm

Electrode guiding plates

If welding with long, angled or "off set" electrodes the tip dresser should be fitted with guiding plates. 

• 640-0316, Fork type guiding plate Ø16,5 mm

• 640-0213, Round type guiding plate Ø13,5 mm

• 640-0216, Round type guiding plate Ø16,5 mm

Quick release unit QR

The quick release unit enables tip dresser exchange within seconds at occasions of inspection and maintenance.

Suspension unit U1

The suspension unit U1 enables equalizing movements of the tip dresser in all directions.

Tip dresser stand Flex-Stand

An automatic installation requires the tip dresser to be mounted on a stand. The main dimensions of the Rotech Flex-Stand can be fitted on site.

• Height, 750-1300 mm

• Arm length, 380-520 mm

Tip dresser Swing-In Stand

The Rotech Swing-In Stand is the solution when working with stationary welding guns.